|
Ether Tap |
 |
|||||||||
 |
|||||||||
|
|||||||||
 |
|||||||||
|
|||||||||
 |
|||||||||
 |
|||||||||
 |
|||||||||
 |
 |
Avoid downtime in your 10/100baseT networks by using the ET100TX. Once in place it enables you to monitor half/full duplex communication and move test equipment without breaking the circuit.
The ET100TX offers a perfect and cost effective solution to tap networks for Protocol, IDS (security), SNMP (management) and RMON analyzers.
Stand alone model
Product N°: ET100TX-SA
|
|||||||||||||||||||||||||||||||||||||||||||
|
Able
to mirror any packet size, bad CRC, VLAN traffic, sees both ends
of full-duplex links.
Fault
tolerant, bypasses data on power failure. Transparent to the
network and none-intrusive.
Supports
the 802.3af in-line power standard and passes power between the
connected network devices. Two LEDs show the presence of 802.3af
power.
The
unit has 4 RJ45 connectors, port A and B are connected in the
network, tap A and B are connected to the analyser. Two activity
LEDs show TX/RX signal activity. The external power is applied to
the back of unit, one power LED shows the presence of power.
Size: 35 x 85 x 110 mm (1.4 x 3.4 x 4.4 Inch). Weight: 155gr (5.5oz). Mains adapter: 90-240 Volt / 50-60Hz / 13.2V - 750mA included. The unit is packed with its mains adapter in a zipper pouch for transport.
The Ether Tap is available also on rack modules.
Rack mount model Product N°: ET100TX-RM
Rack modules are DC chainable, one 13.2V - 750mA mains adapter can supply power for up to 6 ET100TX modules. One DC chain cord is supplied with each rack mount unit.
3 units fit horizontally in a 1U 19" module, 12 units fit vertically in a 4U 19" module.
|
|||||||||||||||||||||||||||||||||||||||||||
|
 |